About Joshua Maurer

Joshua Maurer · 03-20-2018

I understand some of This is not setup for redundancy I am just trying to connect so that EIGRP is working. I have a setup with 2 N7K, distribution switch 3650 and 2 N9Ks. I have a VLAN 5 10.5.5.0/28 7K 10.5.5.2 and .3. 9Ks 10.5.5.13 and .12. Th...

Joshua Maurer · 02-20-2018

I am trying to create a point to point layout between 2 sets of Nexus equipment. Normally you connect the connection directly into the device, but where this comes in it will connect to a switch on both ends for distribution and then connect to the...

Joshua Maurer · 01-26-2018

I am creating a VPN with Cisco 5525-X to a Palo Alto. I am not able to ping or connect to anything on their side but they are able to ping and connect to my side. I have the VPN configured like other VPNs and recently created one the same was with no...

Joshua Maurer · 01-17-2018

Can I have ikev1 and ikev2 both enabled for L2L VPN tunnels? I have not setup a ikev2 yet and just want to make sure I dont take down any of the other ikev1 tunnels. I have a vendor that is asking for Phase1: Encryption: AES-256 Hash: SHA-512 DH: ...

Joshua Maurer · 10-22-2017

I am working with (2) Nexus 7009 in my core and have (2) different ISPs using (2) different ASA's pairs for redundancy. I am running EIGRP for my LAN computers. I have a secondary Data Center that will be connected later but these DC are running inde...

Joshua Maurer · 02-20-2018

I understand this is a single point of failure for both ends. We are only paying for 1 connection that will need to be terminated in the DMARC. Even if I was able to get the fiber up to the top of the building where the server room resides. It would ...

Joshua Maurer · 02-20-2018

I have clients and servers on bother sides. This will be for an existing network to connect the 2 networks together. Each side has their own networks and servers. I would like to connect them with fiber instead of using VPN which is currently used.

Joshua Maurer · 02-14-2018

The ASA was configured correctly. The Palo Alto Firewall was having problems with the NAT traffic when it hit there interface. I am not sure what he fix was for their side but after they had the service call, the tunnel was working with no changes to...

Joshua Maurer · 01-26-2018

I have tried using just 10.18.31.32 as the only host in 5024_LAN with no success on my side Cisco but the Palo Alto site is still able to successfully ping the device. I feel like it is a NAT problem on the Palo Alto side. object-group network S...

Joshua Maurer · 01-26-2018

Yes they are correct. I change the original IPADDRs since this information would be public. 50-53 or the Original 4th octet addresses. I missed that. object-group network Servers_18 description: | 10.18.31.30 - 33 Servers | network-object host 10....

Member Since	‎01-31-2014 06:32 AM
Date Last Visited	‎04-12-2018 06:20 AM
Posts	36

User Statistics

User Activity

EIGRP across Trunk

P2P Connection Between Switch

VPN ICMP one direction

iKev1 iKev2

Nexus Core Redundancy Default Gateway for ISP1 and ISP2

Re: P2P Connection Between Switch

Re: P2P Connection Between Switch

Re: VPN ICMP one direction

Re: VPN ICMP one direction

Re: VPN ICMP one direction