About Road_Warrior

Road_Warrior · 08-24-2017

Hello,I have a requirement to provide site to site connectivity as a backup solution. I have this working perfectly fine. The routers Default Gateway points outward towards the internet. My 2nd requirement is to allow internet access for these remote...

Road_Warrior · 02-07-2019

Sorry for the long delay. This is exactly the solution. Static routes pointing to the peer address of the destination. the data will go down the tunnel.Thanks so much for your reply.

Road_Warrior · 08-25-2017

Okay, So, this kind of makes no sense to me, but I did get it to work. - there needs to be a static route for each network behind the peer address. (old school)- never needed that before, I just had the DG pointing out. and it all worked bacsed on th...

Road_Warrior · 08-25-2017

It is my understanding that all routes defined in the ACL attached with the cryptomap peer address are permitted through that tunnel. There are no routes to route it down a tunnel. It is also my understanding that the tunnel is created via the exter...

Road_Warrior · 08-24-2017

<You defined a static route on the remote router, routing 0.0.0.0 via the tunnel interface? Previously the default route for the remote router was via the internet? ....but the router itself needs a default route to establish the tunnel over the inte...

Member Since	‎08-24-2017 11:53 AM
Date Last Visited	‎02-18-2019 11:41 AM
Posts	5

User Statistics

User Activity

Site to Site ipsec Routing help

Re: Site to Site ipsec Routing help

Re: Site to Site ipsec Routing help

Re: Site to Site ipsec Routing help

Re: Site to Site ipsec Routing help