sunilyk

Thanks Raj.Is it advisable to use same PIX firewall for 2 different ISP's? (By configuring other ava...

Hi,Is it possible to assign 2 or 3 IP addresses to PIX outside interface? (Just like secondery IP ad...

Hi,Thanks for your feedback.CEF is enabled globally.But I can't see 2 routes in show ip route.The sc...

Hi,We have 2 sites say A & B. These are connected by 2 routers each at every site. These sites are c...

Its on Cisco PIX 515 firewall.

Hi,We have done PAT for one VLAN. All the users (approx 50) in that VLAN accesses citrix port (1494)...

Yes, the new address is in completely different subnet.Thanks to all for the valuable info.

Hi,Can we assign 2 IP addresses to the same interface of any PIX firewall (Just like secondary inter...

Hi,The subnet mask is 255.255.255.0Regards,Sunil

Hi,The IOS is 12.3(3) on both the routers.standby command works well on the other router.But the one...

Hi All,We have 2 2600 routers.One router has FE IP x.y.z.252 and the other router FE is x.y.z.253.Wh...

Hi,You need to put an access-list.access-list 101 permit ip (inside IP address range) (Ip local pool...

Hi all,I have a question related to the output of sh isakmp sa on PIX firewall.It shows the output a...

Thanks!But the lifetime for the tunnel is 1 day.So even after this much lifetime, if the supporting ...

Hi,We have established a VPN over the Internet. (PIX to PIX). It shows (sh crypto isakmp sa) that th...