About Julian Ortiz

Julian Ortiz · 01-15-2024

Hi community,I am configuring a SG200 switch for integration with a NAC, I want to authenticate users (802.1X) and phones (MAC), so I need to configure ports with "802.1X and MAC" option. According to the switch guide this is possiblehttps://www.cisc...

Julian Ortiz · 02-14-2023

Hi experts, It was long time ago when I studied BGP, and these days I was doing a lab and got some issues related with the BGP router-id. I found this post:https://community.cisco.com/t5/routing/bgp-router-id-and-loopback/td-p/1611333Herve says "The ...

Julian Ortiz · 06-27-2022

Hi guys, I have a default route which is tracked, the track is up, but the route is not being placed in the routing table. I copy only the relevant configuration: !track 1 ip sla 1 delay down 9 up 3ip route 0.0.0.0 0.0.0.0 10.20.15.1 track 1ip r...

Julian Ortiz · 06-01-2022

Hi community, I need a tip for the following scenario. I have two branches with routers 1 and 2 (R1 and R2). I want R2 reaches the Internet through the upper path (MPLS A), and in case there is something wrong here, it goes through the lower path. Fo...

Julian Ortiz · 09-30-2019

Hi guys, I know Cisco Nexus switches don't support VSS or StackWise stacking, just vPC. The idea is the same and to view the two switches as one from the downlink device's perspective. But I think vPC is more complex, at least in terms of configurati...

Julian Ortiz · 01-17-2024

Yes, Documentation is confusing, because 802.1X Port Authentication Configuration on Cisco 200/300 Series Managed Switches says Applicable Devices: SF/SG 200 and SF/SG 300 Series Managed Switches.

Julian Ortiz · 01-15-2024

that wired?

Julian Ortiz · 02-14-2023

Hi Richard,Many thanks for the clarification, now it is clear Regards,Julián

Julian Ortiz · 06-29-2022

Hi, Just checked and when I no shutdown the interface in the 10.20.15.x network, the default route was placed in the routing table. Then that was the reason Regards,Julián

Julian Ortiz · 06-27-2022

Hi Jon, Then that should be the reason. I have a interface in subnet 10.20.15.x/24, but it is shutdown, because the other ISP end (10.20.15.1) is currently down. If I no shutdown this interface, it will not reach 10.20.15.1 (because is currently do...

Member Since	‎08-28-2017 09:47 AM
Date Last Visited	‎01-23-2024 08:23 AM
Posts	31
Total Helpful Votes Received	12

User Statistics

User Activity

802.1X and MAC option on SG200 switch

Does the BGP router-id need to be reachable?

Tracked default route is not in the routing table

Default route tracks IP SLA - Tip

Stacking on Cisco Nexus switches

Re: 802.1X and MAC option on SG200 switch

Re: 802.1X and MAC option on SG200 switch

Re: Does the BGP router-id need to be reachable?

Re: Tracked default route is not in the routing table

Re: Tracked default route is not in the routing table