We are migrating from our Older Cisco ASA Firewalls to Cisco FTD 2140's. We currently are using WCCP on the ASA's for Transparent Proxy with our WSA Virtual Appliance under VMWare. I was just going to migrate WCCP Configurations to the FTD 2140's w...
Does anyone have any recommendations for a more cost effective Cisco Switch and Wireless Controler Management System than DNA/Catalyst Center? We currently are running prime infrastructure and it works well for our needs. However, since it is going...
We have a couple older 5508 Wireless LAN Controllers supporting a couple hundred 3702 Wireless AP's. These controllers are now EOL. Is there a Wireless LAN Controller that will not only support the newer AP's but also support these older AP's until...
After upgrading from Callmanager 10.x to 14.x Inbound Calls from Cisco 2811 Routers running T1 CAS MGCP to CUCM 14 Fail with the voice prompt "Call Cannot Be completed as dialed". Debugs on the gateway show calls received and digits sent to CUCM but...
On a ISR 4331router every time I reboot it adds the
network-clock synchronization automatic
command to my configuration even though I put in the
no network-clock synchronization automatic
configuration and saved before reboot. This is really annoyin...
Thanks for all the advice and links everyone. They were very helpful. I think I am going to try the WCCP Flex Config and see how that goes. One question though. Do you think migrating the simple configuration from my ASA (only 2 lines plus my ACL...
I actually just found this article on using Flex Configuration on the FTD. It doesn't look that difficult to me. Does this look like something that would work ok on the FTD for WCCP although slightly modified setting it up since this is using the F...
