Coming along Denali 16.3.5b, the IP Device Tracking has been reworked.
I would like to know if it is still possible to use non RFC compliant ARP request with the following command :
ip device tracking probe use-svi (deprecated CLI)
And if it is still...
Hi,
I have this basic configuration to prioritize voice traffic :
policy-map Egress-Queuing class VOIP priority class SIGNAL bandwidth remaining percent 5 class NC bandwidth remaining percent 5 class class-default bandwidth remaining percent 70...
Hi,
I want to do posture compliance for the access network.
For testing purpose I have already manually deployed AnyConnect ISE Posture Module using the predeployment package. I have configured Profile using AnyConnect Profile Editor.
I would like ...
Hi,
I am currently trying to configure Posture on ISE 2.0.1 and the Posture Policy is missing.
It is explicit mentioned in the documentation that Posture rules have to be configured this way.
Best regards,
Florian
Hello guys,
I am fairly new to Posture and I have hence a couple questions :
I have read that the only way to implement Posture has to be done with AnyConnect (since NAC Agent is no longer supported). Is there any way to deploy it without it VPN fe...
I found the solution for the 1st issue (no entries in the database), I actually had to turn on protocol dhcp6 (!) even though this is only IPv4 traffic, very strange ...
device-tracking policy ACCESS_IPv4_GUARD trusted-port limit address-count 5 no p...
Hi Kasper,
I will try to use
device-tracking policy device_tracking tracking enable reachable-lifetime 10
and see if it prevents duplicate IP errors on Windows workstation
But for now I have issues on my catalyst 3850.
I have configured this as a...
The solution is the following :
priority level has to be applied when configuring priority for a class-map
policy-map Egress-Queuing class VOIP priority level 1 class SIGNAL bandwidth remaining percent 5 class NC bandwidth remaining percent 5 clas...
Applying service-policy on the Po is not possible on 3850. I will try to connect and bring the Po up and then apply service-policy on the member of the Po.
For now the Po is down. I have configured the interface like this :
interface TenGigabitEthernet1/0/1 switchport mode trunk udld port aggressive cts manual channel-group 1 mode desirableendinterface TenGigabitEthernet1/0/2 switchport mode trunk udld ...