Dear Friends,I observe the following behavior in N3K-C3172PQ:- We have a VxLAN bridging enabled fabric- In case of subinterfaces on the underlay uplink there is traffic blackhole on egress towards the trunk port where the bridged vlan is allowed - In...

Dear Friends,My network is entirely based on VxLAN bridging and the current spine layer consists of two N9K-C9364C. However as the network grown our traffic exceeded 2T through these switches combined, hence I'm looking to add an additional set of tw...

Friends,Good day. I strongly believe I have a bug to report to Cisco but I don't have any account to do so ;(In short. Two vlans on a N9K-C9396PX.Vlan A is bridged to a VNI and then goes as native to a trunk switchport (A).Vlan B is NOT bridged to a ...

Dear friends,I have a strange issue to share regarding my VxLAN fabric. I'm using two N9K-C9364C for Spines and 3164Q / 9396PX for leafs. They are only doing simple VxLAN bridging of hosts' traffic, so no customer routing etc. /no customer Layer 3 on...

Dear friends,Good day to everybody. We came across an issue with our topology regarding BUM blackholing. As a result of troubleshooting I think we have narrowed it down to a probable mroute issue across our N3K-C3164Q running as leafs. Let's see the ...