I have planned to configure the snmpv3 from snmpv1 on cisco router cisco ASR1001-X. But I am new on this, so can anyone please provide me the script to configure the snmpv3 in cisco router asap,My solarwind server IP: 10.122.1.1 and It would be grea...
I have 2 asas. ASA-A and ASA-B. I want to configure ASA-B as an active unit and ASA-A as an standby unit. Could any one tell me how could i do that? IS there any election process will happen for selecting active/standby units between asa?
Could you any one please answer me the below, What is implicit deny?Why should I have to use it in ASA?How ever, if there is no ACL configured to allow trafffic from Lower to higher security zone in ASA. Then why should I have to configure Implicit ...
Hi Folks, I have been trying to configure multiple access-group in same interface in asa Version 9.1(5)16. But, i am able to configure only on access-group per interface. Can you please clarify me that, how many access-group can be configured per int...
Hi Folks,Could any one tell me, In which interface we need to configure ACL in ASA? for example, please find the below scenarios.Scen:- I have configured 3 interfaces in my ASA, i.e Inside ( sec level -100), outside ( Sec level - 0), DMZ (Sec-level ...
Its looks like a bug please reach cisco TAC.The software defects in Cisco bug IDs CSCul88801, CSCur56395, and CSCut53599 can result in one or more of these symptoms:False "%ILET-1-DEVICE_AUTHENTICATION_FAIL:" messages for the 2960X switch itself or f...
You are pushing irrelevant IOS. Please use the following link to https://www.cisco.com/c/en/us/support/switches/catalyst-2960-s-series-switches/series.html#~tab-downloads And note that 2960S is EOL, you may need to replace the switch asap to get supp...
