Hi, I found the error message that "Unable to fetch configuration" in one of the stacked Cisco Meraki MS250-48FP switch. What will be the cause for this issue and how to rectify this. Another switch in the stack is working fine.
We have two Cisco 1841 routers at branch location. MPLS is connected one router and Internet link is connected with another one. We have configured ibgp between these two routers. Both MPLS and Internet is configured with BGP protocol. We have ...
We have two Cisco 1841 routers and we are running IBGP between these two routers. Two different ISP links are connected in these routers and we are routing particular application traffic via one ISP and rest of the applications traffic via anot...
Spoke location users are facing frequent SAP application disconnection issues. SAP servers are hosted in Data center. Please find the below logs from location Cisco router logs for your reference.
Mar 6 11:59:22.235: %LINK-3-UPDOWN: Interface Seria...
I have created new VLAN for DVR's and it is connected with my core switch 3750G. I am able to ping DVR IP's from my core switch but the same was not able from my access switch from another vlan.
interface Vlan250 description """DVR""" ip addr...
Issue resolved. There was a power disruption in the morning. Due that both Routers got rebooted. Post reboot this issue occurred.
Identified router Id is same in both routers. That has been changed now and Ibgp session established.
We have two routers in same location connected with two different ISP's. These two routers LAN interfaces connected with core switch. PFB required output.
Router 1 output
interface FastEthernet0/0 description >>> Connected to LAN <<< ip...
Observed the misconfiguration of gateway IP in DVR and same has been corrected now. It is working from LAN and same needs to be tested through VPN.
What needs to be done to check via VPN ? Is static route of DVR VLAN segment in core switch po...