About thedquoc

thedquoc · 08-24-2006

Hi , I tried to configure MPLS over a TE tunnel by following this link : http://www.cisco.com/en/US/tech/tk436/tk428/technologies_tech_note09186a0080125b01.shtml#case1 .The problem happened in this tunnel interface config : ----!interface Tunnel0ip...

thedquoc · 08-22-2006

Hello, I have AS5850 router with voice feature cards. Unfortunately, as soons as there are calls flowing through the router it displays error message about DSP timeouts and people calling cannot process the call with busy signal (seems DSP cannot rel...

thedquoc · 08-17-2006

My 2 core routers have total 3 links . Now I want them to enable MPLS ip on their interfaces as P routers, but I am not sure if I should enable on all 3 pairs of interfaces and how it loads sharing MPLS traffic on them . My core routers are runnin...

thedquoc · 08-16-2006

I set up a simple LAB for MPLS VRFthe diagram is CE-PE1-P-PE2-CE .The configurations of all 3 routers are in the attached , I also did some show cmd output . I tried to ping test each pair of vrf ip , from 1 site to other but got time out. Could you ...

thedquoc · 01-13-2004

Hi,I set up my Cisco R-3745 as PPPoE access server, My radius requires clients to send MAC as Calling-Station-ID (attribute 31) to authenticate. But router had never sent Calling-Station-ID to radius. Do I have to change something in the router's con...

thedquoc · 08-18-2006

Hi Martin & Harold,Thank you both for your clarifications . It's very clear now . I much appreciate your helps .Once again thank you !

thedquoc · 08-18-2006

Hi Olorunloba,Thank you for your help !Regards,

thedquoc · 08-17-2006

Hello,Thanks you for your reply !As I get from your msg , for my scenario , when enable MPLS ip on all 3 pairs of interface (3 links between 2 P routers) . The MPLS loadsharing is then like that of a etherchannel , am I wrong ? and does my EIRGP ro...

thedquoc · 08-16-2006

OK, I got it . Now it's working . Thanks a lot for you great help !

thedquoc · 01-27-2004

Yes, I enabled auth & acct . But the problem here is that the router does not send Calling-Station-ID (attribute 31) to radius so clients cannot login (my radius server requires MAC address as Calling-Station-ID to authenticate)Here below is my route...

Member Since	‎01-09-2004 02:42 AM
Date Last Visited	‎08-18-2017 03:51 AM
Posts	12

User Statistics

User Activity

MPLS over a TE tunnel

AS5850 Voice problem

P-to-P load sharing ?

MPLS-VPN does not work , pls help !

Need help for PPPoE server authenticating

Re: P-to-P load sharing ?

Re: P-to-P load sharing ?

Re: P-to-P load sharing ?

Re: MPLS-VPN does not work , pls help !

Re: Need help for PPPoE server authenticating