Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello all,Since I do not have access to the TAC, I figured the best place to tell Cisco about this problem is on here, please let me know if there is a better way to report bugs if you do not have TAC access.I searched the bug db but couldn't find an...
I am currently building a network consisting of several >10km links, so we are using ZX GBICs. However, some of the links are under 30km, so according to http://www.cisco.com/en/US/products/hw/modules/ps872/products_data_sheet09186a008014cb5e.html, w...
I would definately go for the second design. This is much more scalable (what if you add another VLAN? You would have to add a new cable to each accesssswitch!). This really is wat trunks were invented for.Some other thoughts:- Try to avoid the use o...
Sureh,Please read my message again, it is not me who enters the command wrong, it's the router itself that enters a command into startup config that it after a subsequent reload does not understand.Jeroen
For outgoing traffic (+ return traffic) it should not be so hard, although you will probably need some fiddling to get a somewhat even loadbalancing over the lines.For incoming traffic (such as a hosted website or hosted applications), it is quite di...
I now see that you are in fact mentionning that in the first post.Is there high utilization on the link you shut down to resolve the issue?Have you tried changing this link to a different port/card on both switches?You could try leaving a PC plugged ...
