gleithner

mode access is usually for end devices attached to the port. there's no reason really to trunk unles...

statements are evaluated in order..once an interface is matched to an area, the interface won't be c...

not that I know of. If we're talking a new device, you could use 802.1X or mac-security on the switc...

what are the port counters showing? Any other config differences between the two ports?Did the mac a...

You can open up the necessary ports on the firewall, but I don't really recommend that. A better sol...

When policing or shaping, is the average rate variable akin to frame relay's CIR? That's the way it ...

If you are talking about the Identifier field in the IP header, then it's only useful if you somehow...

lookup private vlans on the cisco main site. They are basically a way to isolate ports even further ...

it should work. SX to SX

I think your only options are to upgrade the pix to one that supports trunking(or multiple interface...

I believe the only way you could trunk over a WAN is via ATM Lane. If you try to bridge, I'd imagine...

I believe they'll be routed to the default gateway. If you need dest unreachables, you could always ...

You'll want to set up a trunk and VTP. I think the 2950 only allows 802.1Q trunking so you'll go wit...