Hello,
Sorry about that, I actually thought instructions I sent to you had included the 'init system' command, this command will wipe the FI.
I would suggest, ff you don't have the admin password, you can just reset that password to allow you log i...
Hello,
Here is a community forum on how to rebuild the Fabric Interconnect software: https://community.cisco.com/t5/data-center-and-cloud-knowledge-base/how-to-recover-from-a-software-failure-on-the-6120-fabric/ta-p/3121751
NOTE: To boot to the loade...
Hello Beyond,
Check faults being seen on UCSM. Check pmon state, if any pmon state is showing failed, you will need to perform pmon restart in cli. Commands:'pmon stop' 'pmon start'. You may also reboot the fabric interconnect to recover pmon resourc...
Hello Eddy,
Try the following documentation: https://www.cisco.com/c/en/us/support/docs/servers-unified-computing/ucs-manager/200869-Add-Virtual-Drive-in-the-Modular-RAID-Co.pdf
Also, you can upgrade server via HUU using USB: https://community.cisco....
Hello Han,
What type of USB are you using? USB 2.0 or 3.0? Also, what brand/model/size is the USB?
Please note if it's USB 3.0 device, we will need to configure a xHCI controller on the virtual machine which needs to be connected: https://docs.vmware...