Hi there, We've got two data centers that will be connected over 2x10G links, and we're deploying L3 vSAN Stretched Clusters (2x Clusters with 4 hosts node in each cluster)) across the two DCs. We are adding 4 nexus 3548-X switches to the existing ne...
Hi there!I'm seeking some help and advice with our current network setup.Basically, as you can see from the network diagram attached; we're deploying vSAN Stretched Cluster between two data centers (2x Clusters with 4 hosts node in each cluster). We ...
Hi there,We've got a standalone ASA 5525 which is connected to the core switch with single physical interface for the LAN and other for the Internet.Now, our ISP needs to change the IP address of the Internet link with a complete different range.So, ...
Hi there,We need to replace our existing stacked of two Catalyst WS-2960X-24PS-L with a new stacked of two Cisco 9200 Switches.At the moment the 2960 switches are configured as L2 switch and it's connected over 1 fibre cable to the core switch C9300....
Thanks so much for reply.Has the firmware code 3.7.xE been discontinued? If yes, I can't see the point of upgrading it.I don't have any objections on upgrading the stack (and new member) to the recommend and stable version by Cisco if it's the right ...
I'm not quite sure if the above config will work as private IP address 192.168.1.1 >> can be NAT once outside. I mean I can't see how any websites be accessible from outside.I'm thinking of what you suggested earlier :- Website A will be using port 8...
Thanks Tyson!In this case I will need to create 3 network objects for the same private web server, and create 3 NAT rules for each network object as follow : WebServer=WebServer2=WebServer3= 192.168.1.194object network WebServer
host 192.168.1.194
n...
Thanks Tyson!The webserver will host 3 websites and each website will have a separate public IP address.I presume that the NAT rule you created above should be from DMZ to Outside (DMZ,Outside), and not from (Inside,Outside)?Thanks
