Hi Everyone,
The company that I'm working for will be decommissioning x4 Cisco ENCS 5400 nodes.
We would like to format the hard drives and install VMWare workstation for a labbing environment.
Is this possible and has anyone done this before? If yes...
Hi Everyone,
I am busy testing a postman script to configure and remove static routes on the APIC(physical lab. version 4.2(7f)).
Below is the json script in postman and I use a runner to reference a .csv for a list of ip addresses:
{
...
Hi All,
May you please advise on the following:
We are currently busy with a firewall migration project that will be utilizing multiple vdoms.
The internal interface of the firewall will be configured with sub interfaces and each sub-interface ip add...
Hi Everyone, Below is an error message that i detected on the ACI fabric and was not very descriptive to investigate on which EPG's are in the freeze state.I had a look on the internet and could not find much information, besides a 'show command' to ...
Hi Guys, I am currently busy with a project to implement a wlc 2504 anchor controller for guest wifi. The foreign controller is a wlc 5508 and the anchor controller is currently in the dmz behind a firewall. The tunnel is up up between the two contro...
Hi Sergiu,
Thanks for your prompt and valuable response.
I was sending a POST for creation and a DELETE for deletion of static routes. I see where i made my mistake and i did not send a POST to change the STATUS attribute (which makes sense). I will ...
Hi Sergiu,
So, basically you can have multiple SVI's to different paths in a LIP but not multiple SVI's to the same path in a single LIP?
Makes sense.
Many thanks for your valuable assistance.
Hi Sergiu, Thanks for your response. I had a look and it is related to an issue that we are busy resolving.My only concern was the error message; stating that the EP's are in a freeze state.Is there any impact on the endpoints?
Hi GPinero,That's correct. Upon further investigations (debug client mac-address) on both the Foreign-and-Anchor wlc. We realized that the Anchor controller receives the request from the client and is authenticated using a PSK but the client is dropp...
