I am trying to configure an ipsec tunnel between two 8000v routers.I am using a source interface of a loopback and a destination of a loopback on the other router. These loopbacks are reachable from each other. I should mention that this is all co...
When trying to commit the interface configuration I get the following message - Aborted: values are not unique: eth0'vpn 0 interface eth0 if-name''vpn512 interface eth0 if-name' My config is - vpn0 Interface eth1 Ip address 10.20.129.151/24 no shut...
I am trying to register an ASAv via my Satellite server but when I test the smart call home profile via CLI to my satellite server I get this message. call-home test profile LicenseINFO: Sending test message to https://F.Q.D.N/Transportgateway/servic...
I have my HyperFlex installer stood up and configured, but now I need to change it's IP address.
Is there a method for doing this?
Any caveats to doing this?
Thanks
I am preparing to stand up my first HyperFlex cluster for which I plan on migrating VMs from a traditional compute and SAN based storage install.
I have been reading the install and config guides and have a question that I am not really finding ...
I am running ASAv version 9.14(1) and satellite version 7-201907 I was able to 'debug call-home all' and 'debug license agent all' but the other debug commands didn't work. Debug output shows - call-home test profile LicenseINFO: Sending test messag...
That’s what I am trying to do is the more planning.I can get the same VLANs across the underlying network by trunking through the network to both new and old hosts.Under 1 vCenter I didn’t think I could have a portgroup named ‘web’ on old dvs and new...
