Hello Oliver,
That is correct. Starting from 9.3(x) the PLB feature is deprecated.
Its functionality is now replaced by ITD.
While trying to enable PLB feature with 9.3(x) you will now be presented with the following error message:
switch(confi...
Hello,
Let me clarify on few points of your question:
1. The peer-gateway feature will play a role when the VPC switch is performing routing. It will not make much difference if the device is just L2
2. Peer-gateway does also play a role in healthy...
Hello,
As I mentioned in my previous post, there is no limitation on VRRP which would require the same group number to be used on multiple SVIs.
I did run few quick tests in the lab with N9K-C93180YC-FX running different software versions: 7.0(3)I7...
Hello Didier,
There is a strict requirement that all nodes within a device-group must belong to the same vrf – vrf name needs to be specified under device-group configuration. So, in this aspect we are not allowed to “mix” multiple vrfs.
However,...
Hello Oliver,
PLB (Pervasive Load Balancing) is a feature, which allows the fabric to perform as a load-balancer.
The main functionality of the feature is to distribute the load between resources (servers, vms, containers) scattered throughout the en...
