I have installed Cisco Collection platform(CSPC) 2.8 and added all the devices into CSPC. After that i have created the Collection profile and then create upload profile, here the collection profile is showing blank.
Hi, One of our Cisco 4507 is config mode is locked. Power consumed by backplane : 40 WattsMod Ports Card Type Model Serial No.---+-----+--------------------------------------+------------------+-----------1 48 10/100/1000BaseT (RJ45) WS-X4648-RJ45-E ...
Hi,We are having Cisco DX80 CE 9.5.2 and CUCM 10.5.2.Need to register the DX80 using MRA.Configured below. CUCM1. Configured in CUCM.2. Associated the End UserDX80:LoginName: <UserID>Mode: EdgePassword: <Password>Domain: <yourdomain.com>Protocol: HTT...
Hi Friends,
We have one SX10 and MXP600 is located in the same building, when we try the point to point calling and call is not going through.
MXP6000<--->CUCM<--->SX10
This issue is there within the building and from one building to other buil...
Hi,
We have Cisco 4321 with UCS-EN140N-M2. I have configure the CIMC and it's not able to access.
interface GigabitEthernet0/0/0 ip address 10.100.30.20 255.255.255.0 negotiation auto
ucse subslot 0/2 imc access-port shared-lom console imc ip ...
Where I can get the SNTC Profile, I could see one profile in manage profile section which is “SNTC EVALUATION”.This is also not coming on the upload profile. Please advise.Thanks in advance.