qbakies11
Level 1
Level 1
Member since ‎02-15-2007
‎08-18-2017

User Statistics

  • 173 Posts
  • 1 Solutions
  • 99 Helpful votes Given
  • 3 Helpful votes Received
Recent Badges
1 Accepted Solution
1 Helpful Vote
50 Replies
20 Replies
10 Replies
5 Replies

User Activity

I have a 1941 that I am going to deploy with a HWIC-D-9ESW switch module (I only need 3 switch ports but need the PoE).  I am going to hang a 1262 autonomous AP off one of the ports but I need to configure MAC address port-security so that only that ...
I'm trying to study for the CCNA Security test and need to be able to setup zone based firewalls instead of CBAC. I have tried all of these images and when the SDM loads (v2.5) it has CBAC firewall, not zone-based:c1700-adventerprisek9-mz.124-23.imag...
I recently installed a WIC 1DSU-T1-V2 card into a 1841 router to add to a multilink bundle.  I inserted it in Slot 1 and powered up the router and there was a new serial interface showing in the config automatically as s0/1/0.  I was able to get it s...
SiteA and Site B are connected Point-to-Point with two 1.5 Mbps T1 lines.  In order to bundle the traffic into a single 3 Mbps line I have created a Multilink group and added both lines to it on the router at each site.  Recently we have been having ...
I have a client who wants to make changes to a PIX 501.  They have a single server exposed to the world and want to have specific traffic sent to it.  I was going to set up static NAT for the server and then create a simple ACL to allow the ports the...
Community Statistics
Member Since ‎02-15-2007 06:03 PM
Date Last Visited ‎08-18-2017 03:51 AM
Posts 173
Total Helpful Votes Received 3
Helpful Votes From
Helpful Votes Given To