About jpmckane

jpmckane · 04-04-2005

I'm currently using a 2620 with a T1 for Internet access. I'm looking at adding another 1.54 of bandwidth, however this increase would be via ethernet (originating from a wireless antenna). Is it possible to bond serial and ethernet interfaces togeth...

jpmckane · 07-12-2004

Hi all,I have a CM publisher and subscriber connected to a 3660 hosting a PRI using H.323. When the publisher is removed from the network, the subscriber takes over and all the phones failover correctly. However I'm not able to receive calls into my ...

jpmckane · 12-05-2003

Hi all.The literature for the 7935 states that it can do meet-me conference calls. I've tried starting a meet-me call from a 7935, but there doesn't seem to be a meet-me softkey. Anyone know how this is done.Thanks for any help.

jpmckane · 04-04-2005

Thanks for your reply. I'm assuming from your answer that interfaces can be bonded regardless of their physical nature, ie ethernet can be bonded with serial to form one pipe?

jpmckane · 07-12-2004

Just curious to know what the answer was. I'm in the same situation where I'm trying to provide failover for the AC client in the event the primary CM goes down.Thank you

jpmckane · 07-12-2004

I thought that was what I would have to do but wanted to confirm it.Thank you for your response.

jpmckane · 10-09-2003

I have similar problem with my Unity. The problem was that when people would call into Unity they would get a busy. A check of the status page showed that only the first port was busy, all others were free.The problem for me was this: When a call i...

Member Since	‎10-09-2003 08:56 AM
Date Last Visited	‎08-18-2017 03:51 AM
Posts	7

User Statistics

User Activity

Bonding a T1 and Ethernet interface, is it possible?

Dialpeer failover to subscriber

Starting a meet-me conf call from 7935

Re: Bonding a T1 and Ethernet interface, is it possible?

Re: Attendant Console - TSP setup?

Re: Dialpeer failover to subscriber

Re: Incoming calls to VM get fast busy