Cisco Community
English
Register
Register
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Eduardo Camio
‎06-13-2020
Beginner
Recent Badges
Awards
Recent Badges
See all
5 Replies
Stats
Member since ‎07-21-2006
13
Posts
0
Helpful
0
Solutions
Certifications
Cisco Certified Design Associate (CCDA)
Cisco Certified Design Associate (CCDA)
Cisco Certified Network Associate Routing and Switching (CCNA Routing and Switching)
Cisco Certified Network Associate Routing and Switching (CCNA Routing and Switching)
Cisco Certified Network Associate Routing and Switching (CCNA Routing and Switching)

Re: Switch 2960s doesn't power an iw3702 ap

Created by in Routing
07-10-2018
07-10-2018
I will double check with people on site about physical connectivity.It's supposed that the AP is con...

Re: Switch 2960s doesn't power an iw3702 ap

Created by in Routing
07-09-2018
07-09-2018
Leo, Thanks for your help, below the output required: 2960Sw-01#show cable tdr interface gi1/0/23TDR...

Re: Switch 2960s doesn't power an iw3702 ap

Created by in Routing
07-07-2018
07-07-2018
Yes it is enable. I can see other cisco switches.The ap is not visible because it never powers up.

Switch 2960s doesn't power an iw3702 ap

Created by in Routing
07-07-2018
07-07-2018
Hi all, I have the following issue. I'm connecting an iw3702 ap directly to a WS-C2960S-24PS-L and n...

Ciscoworks - HUM pollers "Yet to Start"

Created by in Network Management
03-07-2012
03-07-2012
Hi guys, I'm configuring some new pollers into HUM module on CW 3.2 but for these i see the "Yet to ...

Re: CiscoWorks - LMS 3.2 - Can HUM monitor the following?

Created by in Network Management
03-18-2011
03-18-2011
Thanks for your reply.The primary goal behind this pollers are not real-time graphics monitoring but...

CiscoWorks - LMS 3.2 - Can HUM monitor the following?

Created by in Network Management
03-17-2011
03-17-2011
Hi guys, I had been asked to monitor some resources in servers with the HUM module but I am not sure...

Re: DFM: Alerts and Events doubt

Created by in Network Management
09-13-2010
09-13-2010
Thanks Joseph and I will take your recommendation to use events instead of alerts.Regards.

Re: Problem with HUM and Cisco 6500

Created by in Network Management
09-07-2010
09-07-2010
Would this template works for a 3750?Thanks.

DFM: Alerts and Events doubt

Created by in Network Management
08-31-2010
08-31-2010
Hi guys, First of all please forgive my ignorance, but could someone give the specific difference be...

Re: Router cisco 2851 reboots continuosly

Created by in Other Network Architecture Subjects
01-08-2010
01-08-2010
If I use 12.4(9)T or earlier the 2851 starts well.

Re: Router cisco 2851 reboots continuosly

Created by in Other Network Architecture Subjects
12-29-2009
12-29-2009
Which VPN card do you mean?? Right now there are no cards installed in the chassis. If you are refer...

Router cisco 2851 reboots continuosly

Created by in Other Network Architecture Subjects
12-28-2009
12-28-2009
Hi folks, I'm having this issue since I update the IOS from 12.4(9)T to 12.4(24)T2. So I tried 12.4(...
Public Statistics
Date Registered ‎07-21-2006 08:13 PM
Date Last Visited ‎06-13-2020 11:33 AM
Total Messages Posted 13
Helpful Votes Given To
See all >