We recently moved a pair of WLC 5520's into a new cage. Once powered up, the console port does not seem to be responding. The console was responding and accessible prior to the power down and move. Has anybody run into this before? What was done to f...
We recently migrated a pair of 4451 CUBE routers into our ACI fabric. Once we migrated layer 3 into the fabric, we started seeing issues where the CUBE VIP would go unresponsive for a minute or two - which takes the SIP trunk offline and drops all ac...
We are in the process of moving our HPE NonStop environments into our ACI fabric and have run into some performance issues. On the NonStop side, they are running a bond interface, with two interfaces in the bond and the bond setting as "balance-alb" ...
We are in the process of implementing a NO NAT configuration on one of our firewalls and are running into an issue. We have created an object-group for source IPs that will have the NO NAT configuration applied. object-group network NO_NAT network-ob...
I am working on implementing emergency call routing to RedSky for our remote user base. RedSky will accept TCP, UDP, or TLS traffic to their SIP gateways and they provide very little guidance on how calls should be routed to them or how communication...
Currently running 8.5 but upgrading to 8.10 this weekend. We've been held back because we have some older APs, which we are moving off of these controllers. We tried swapping cables between the controller and console server; we tried moving a cable f...
Thank you for this. I found it earlier and worked through all steps to no avail. I ended up configuring the CIMC - which nobody had configured previously - and was able to console into the primary controller that way. The only issue with that workaro...
