Hi Samteo, Use a data port such as Tw0/0/0, delete the device from PNP inventory, & retrigger PNP discovery from the 9800 CLI:-- 'pnp service reset no-prompt'

Hey Eekman, I am not aware of any documentation that goes into this detail however I hope I can help provide some clarity to your questions. If the 6GHz slot 2 radio is up and operational, yes the API output should provide 3 outputs which are comma d...

Can you provide the output of the following command from the eWLC CLI?: show telemetry internal connection The 'State' should show as 'Active' which indicates the 9800 is successfully sending telemetry data to Catalyst Center. Do you see any indicato...