Ey there, very ease question, but i just dont know how to do it.I need to close port 22 on a cisco router, what command do i need to do this?And is there a way to see what ports are open?Thank you!
Ey there. I have a few cisco 800 series routers. And i want to set up a priority list.I want to give HTML traffic a higher priority then telnet traffic (over IP)When i go to the priority list command, then i go to IP, i can just change the priority o...
I was wondering. Can i somehow change my bandwidth for a location and limit the bandwidth for another?For example; 70% of my bandwidth goes to 192.168.x.x, and 30% goes to 192.168.y.y (x and y are different locations but both on the same interface (e...
Hi again!Well here's another problem. I've got 2 locations connected by 2 828 cisco routers. On one side i have a pixie server(is pixie spelled correctly?), on the other location i have thin clients that automatically search for the pixie server(we d...
I have to test a network today that is working with DHCP. There is a DHCP server on another location that works fine. I configured a router on another locations (cisco 828) with the following commands:ip helper address 192.168.1.3 (dhcp server)ip dh...
Jolmo? what's that?I check a 2500 router and i works! But the prob is, the real router that i have to configure is a 827!What do i need to do, to let it work on that? (everything is connected on the eth0)
woow going a bit fast m8.How do i do all that? (commands)Do i have to make those acces groups? (if yes; how?)Here's the config of one router, maybe it will help. Thnx!!Current configuration : 1428 bytes!version 12.2no service pad!no logging buffered!...
Well thnx so far. Just one more question. The ip-helper-address is being used by the DHCP server, not the same adress but can i put in two helper addresses??And do i have to configure something on the primairy router?secondary router: ip helper-addre...