Hi you all When doing a radioactive trace on a C9800-CL, it starts the the trace but, when we chose to generate the log it says ->Not enough free memory to run this command, aborting. Unfortunately I do not know the hardware layout on the hyper visor...
Hi Fesk6895 Yes I found a solution.Converted 9800-CL about from bundle to install mode.And as far as I know, Install mode Cisco is recommended. https://www.cisco.com/c/en/us/support/docs/wireless/catalyst-9800-series-wireless-controllers/217050-conve...
Unfortunately, the above did not work. VM is create via OVA, resources are allocated via OVA config.4 cores, 8 GB ram, 16GB storage. there is 3GB available out of 6.2GB one the boot flash
