Is there a VPN client for Windows 10 for the WRP500 router.  The built-in Windows 10 VPN client does will not connect to the router.  Thanks.

Is it possible to config the E0/0 port on the Cisco 2600 router to access the FE ports on the on-board NM-ESW-16? There is only one Ethernet port on the router.

While downloading new IOS, original flash was erased. New IOS did not load because of insufficient memory. Router has no flash and boots up in ROMMON mode.Everyy time I try to TPTFDNLD a copy of the old flash, the reply comes back with set of IP a...

Please see the previous messages below exchanged on this site. The boot version on the router is as specified below. However, when in the interface mode, the encapsulation command is non-existent, so I am unable to encap the sub-interfaces with ISL...

For a classroom lab assignment, I am attempting to route several VLANS from a Catalyst 3524 switch via a Cisco 2621 router. The switch port on the switch is configured as a trunk switchport and is connected to F0/0 on the router. My problem is that...