About jtrogdon

jtrogdon · 11-04-2004

I have three Cisco routers and a Netopia Cable modem router. The Commerce network is setup as 192.168.4.0 on Serial0 and 192.168.5.0 on Ethernet0. The Plant49 router is setup on network 192.168.4.1 on Serial0 and 192.168.2.1 on Serial1 and 192.168....

jtrogdon · 04-12-2004

Cisco 1005 ----- Hub --- PC | |WAN T1| Cisco 1700 ---- Hub - Cable Modem RouterThe Cisco 1005 has the Ethernet setup as 192.168.5.x and the Serial setup as 192.168.4.x. The Cisco 1700 has its Ethernet setup as 192.168.3.x.From the PC, I can ping m...

jtrogdon · 11-11-2004

I think I finally got it figured out. Since I needed to NOT have the static route distributed over RIP I did this:router rip distribute-list 3 out access-list 3 deny 0.0.0.0 Access-list 3 permit 0.0.0.0 255.255.255.255That denies routes that a...

jtrogdon · 11-08-2004

I have attached my "show ip route" results for each plant. Thanks very much for your help.

jtrogdon · 11-08-2004

I have attached my router configs for you.

jtrogdon · 11-08-2004

Ok, I ran into a problem when I added the static address at the Plant49. My email server is located at the Central plant. It looked like it picked up the static route via RIP was redirecting incoming traffic to my 192.168.2.0 network. I removed th...

jtrogdon · 11-04-2004

Thanks for the response. I'll try that as soon as possible.By setting up these default routes will this in any way interfere with regular IP traffic on my 192.168.x.x network? In other words, all my 192.168.x.x devices can see each other without a...

Member Since	‎04-12-2004 08:12 AM
Date Last Visited	‎08-18-2017 03:51 AM
Posts	7

User Statistics

User Activity

Tracert and Default Route

CISCO 1005 Internet Routing

Re: Tracert and Default Route

Re: Tracert and Default Route

Re: Tracert and Default Route

Re: Tracert and Default Route

Re: Tracert and Default Route