About chung689

chung689 · 01-08-2022

Hi all,I tried to reconfigure a 3750 switch with startup config erased. After I issue the command "speed 115200" under the console line configuration, the terminal was stuck at this point. I thought it would work if I reopened the console session wit...

chung689 · 10-02-2019

Hi all, I have around 50 2702 APs joined to a WLC5508, however, some of the APs are occasionally reset by controller. One of the APs reboots more frequently than other APs for around 3-4 times a week. The controller software version is 8.3.133.0 and ...

chung689 · 08-21-2019

Hi everyone, I want to look for the BSSID MAC address of the SSID of my Meraki. Is there a way I can check in the dashboard ? Thanks.

chung689 · 01-08-2022

I used the same computer same serial console before and after the command "speed 115200" was issued. Then I rebooted the switch, as the switch had its startup config erased, I assumed it rebooted as factory default. The terminal showed the output nor...

chung689 · 10-03-2019

Please refer to the attached txt file "show version" and "show interface controller output", thanks

chung689 · 10-03-2019

Hi Leo, thanks for your reply, the "dir" output is as followed. FYI reference the ap was reset today at around 9am (GMT+8) and joined WLC at 09:03:49.499 (GMT +8) AP1#dirDirectory of flash:/2 -rwx 145 Oct 3 2019 01:03:50 +00:00 capwap-saved-config3 -...

Member Since	‎10-12-2017 12:35 AM
Date Last Visited	‎01-14-2022 12:02 AM
Posts	6

User Statistics

User Activity

Console does not accept input since speed command is issued at switch

2702 reset by controller 5508 for unknown failure reason

Cisco Meraki MX64W BSSID MAC address

Re: Console does not accept input since speed command is issued at swi

Re: 2702 reset by controller 5508 for unknown failure reason

Re: 2702 reset by controller 5508 for unknown failure reason