About sysadmin@cwcmh.org

sysadmin@cwcmh.org · 04-19-2024

Where do i find the complete guide on my switch?This is the model number WS-C2960X-48FPS-L.The software version is c2960x-universalk9-mz.152-2.E3What I'm looking to do is limit how much bandwidth is allowed on an interface. The network at that site o...

sysadmin@cwcmh.org · 03-18-2024

I need some help with configuring an autonomous 1142 ap. I enter the GUI set up two vlans 100 and 200. vlan 100 has corporate wifi and vlan 200 has guest wifi. I signals appear on my phone but when i go to connect to them I don't get an IP address. I...

sysadmin@cwcmh.org · 02-23-2024

Have an autonomous ap im configuring for use. When i enter the password in ASCII format it tells me I can't use a ? character. Is there any way around this? This is my software version,Cisco IOS Software, C1140 Software (C1140-K9W7-M), Version 15.3(3...

sysadmin@cwcmh.org · 01-23-2024

I have a cisco 2500 wireless lan controller software version 8.0.152.0 with 60 access points that are model AIR-LAP1142. I know these products aren't supported but I do believe there is a simple fix for my problem. Out of the 60 access points 5 aren'...

sysadmin@cwcmh.org · 01-02-2024

I have several AP's that all connect to a WLC just fine. There are some AP's that have lots of clients though. Most of my APs have 3 to 9 clients which shouldn't be too bad. One of the APs has 23 clients on it, however. How do I configure load balanc...

sysadmin@cwcmh.org · 04-19-2024

Is the AP not working? Does it have a boot loop? Does it finish the boot sequence?

sysadmin@cwcmh.org · 04-19-2024

So you noticed that one AP is causing the drops right? Is one laptop dropping connection to that specific ap? or more than one user?

sysadmin@cwcmh.org · 04-19-2024

I'll be frank and tell you that I'm not familiar with QOS or policing so my config will not be acurate.this config is on the AP.dot11 ssid Test Rate Limitvlan 2rate-limit tcp input data-rate 500000 burst-size 500000rate-limit tcp output data-rate 500...

sysadmin@cwcmh.org · 03-21-2024

Thank you very much. I was able to add dhcp on the ap itself and ip addresses were being assigned. I could also use the dhcp server on the windows vm. Options are good. I appreciate the help.

sysadmin@cwcmh.org · 03-19-2024

Thanks for the assistance. The dhcp server is on a windows server os vm. I tried to add a dhcp server on the ap itself but it didn't add ip addresses when trying to connect

Member Since	‎10-12-2017 03:21 PM
Date Last Visited	‎04-24-2024 12:05 AM
Posts	29
Total Helpful Votes Received	1

User Statistics

User Activity

Need a complete guide for WS-C2960X & how do i configure policing/qos

Assistance configuring multi SSID Air-lap 1142

Setting a wpa2 Password on Cisco 1142

Some of my Access Points aren't joining/accepting clients

Need Assistance with old AP Aironet 1142: Load Balancing

Re: I acquired 2 aps cisco 9120ax from one soon to the next, it does n

Re: wifi network drops during the day - AIR-AP2802I-Z-K9

Re: Need a complete guide for WS-C2960X & how do i configure polic

Re: Assistance configuring multi SSID Air-lap 1142

Re: Assistance configuring multi SSID Air-lap 1142