About x00008037

x00008037 · 01-24-2023

Has anyone got experience with creating templates for IE3300 devices. I want to configure REP Primary interface and also REP Edge interface on one device with a template but want other config for the REP interface's on the rest of the IE3300 device's...

x00008037 · 04-26-2022

does anyone have experience with this or can perhaps guide me on this question If i have a Distribution device with 100 Edge device hanging off the Distribution all L3 and i want to enable Netflow to export flows to the collector. Isn't the distribut...

x00008037 · 11-18-2021

Has anyone done or know if this type of REP Topology would be supported in SD-Access and DNA-C. I know the individual REP rings are supported when connected to the same EDGE Node. but can you stretch the VN/VLAN (Enable Broadcast) across the fabric t...

x00008037 · 07-20-2021

If combining 2 ISE Personas on one VM or on one Appliance do i have to scale the VM up to accommodate. Example one admin node as a 3655 is spec (96GB + 600GB HD) but if i combine ADM+MNT+PXG do i need to scale up this node to cater for the extra pers...

x00008037 · 06-20-2021

Does anyone know what the minimum size of an ISE Medium Distributed Deployment is ? From Cisco Documentation i can only see that ISE 3.0 will support <=6 PSN when the PAN and MNT are combined as one persona. I want a Hybid deployment of PAN/MnT/PxGri...

x00008037 · 01-17-2023

Hey Mate Yes i have just deployed this setup. One DNAC at DC1 One DNAC at DC2 and witness VM at another Remote location. to address a DNAC we used the following. Ent IP addressEnt VIP Address Cluster IP addressCluster VIP Address Both separate subnet...

x00008037 · 12-07-2022

Good Question, Cisco's documentation is not very clear on this. i also have two 9500 that i want to LAN automate. Im going to approach it like thisLAN automate the two devices and any other Edge device that connects to them, Then convert the two devi...

x00008037 · 02-10-2022

thanks for that Greg that clears it up. I wasn't sure how particular you could get with the AD groups. As we will be pushing an SGT to a user , based on their AD group. The machine will do cert based authentication

x00008037 · 02-10-2022

Hey seen this thread. I would be interested to see your Authorization policy that allows a certain user in a AD group to get an SGT and to get authorized while using eap-chaining and teap. Im trying to figure out the best Autz policy to create to aut...

x00008037 · 01-16-2022

Hey mate, did you build the DR site, My question is did you have both DNAC ent interface in separate subnets ? Also what subnet is the floating VIP advertised via BGP in? were implementing this now and Cisco documentation is not great on how-to set i...

Member Since	‎10-12-2017 09:53 PM
Date Last Visited	‎05-07-2024 08:00 PM
Posts	55
Total Helpful Votes Received	11

User Statistics

User Activity

DNAC Template IE3300

Stealthwatch Flows

SD-Access REP Support

Cisco ISE 3.0 Sizing

ISE 3.0 Scaling Medium Hybrid Deployment

Re: DNAC Disaster Recovery

Re: Cisco 9500 Stackwise Virtual and DNAC PnP

Re: EAP-TEAP: First time user login/chicken & egg scenario

Re: EAP-TEAP: First time user login/chicken & egg scenario

Re: DNAC Disaster Recovery