About austinwilly

austinwilly · 03-09-2023

Hey All,I need some direction/Advise. A cluster that I've been brought in to help with is in a really tricky situation. After a 2 drive failure in a RAID 5 array their PUB and 2 SUBs are just BOOM. No hope of recovery and drives have been replaced to...

austinwilly · 03-09-2023

Turns out The DRF Master service on the Sub was stopped. It was in a "Commanded Shutdown" state. I restarted the DRF master service on the sub (and restarted the DRF Local service for good measure) and repeated the procedure and was able to recover t...

austinwilly · 03-09-2023

I would love to speak to TAC on this issue.EOS EOL hardwareEOS EOL softwareSomeone let SMART lapseTAC wont help, been down that road already. I'm prepared to Rebuild this cluster from scratch if necessary. This post is just a last ditch attempt to se...

austinwilly · 04-01-2021

Hi all, CUCM 12.5 close to the same issue but interestingly enough when i point directly at an LDAP server it works or if im using LDAP port 389 no TLS it works. I only experience the issue when I'm pointed at a VIP and using LDAPS with TLS enabled ...

austinwilly · 08-07-2018

The method I have been using is described here but for MGCP not SCCP. https://www.cisco.com/c/en/us/support/docs/unified-communications/bulk-administration-tool/118882-config-vg-00.html

austinwilly · 08-07-2018

I am having this same issue. My problem though is that I've inserted the gateways via the bat.xlt and am attempting to update the line info (Line description, alerting name, ect...) with this method. Why does a gateway exported from Call Mangaer 10.5...

Member Since	‎10-13-2017 01:15 PM
Date Last Visited	‎03-19-2023 09:44 PM
Posts	6

User Statistics

User Activity

Recover Publisher from Subscriber

Re: Recover Publisher from Subscriber

Re: Recover Publisher from Subscriber

Re: CUCM LDAP Sync response - zero results

Re: Bulk Update VG350 ports

Re: Bulk Update VG350 ports