About lucas_kaczmarski

lucas_kaczmarski · 08-10-2018

Hello, Does anyone know how to force Cisco ASA to send GARP for NATed IPs? I'm using proxy arp and the ARP entries on the upstream device do not refresh after I change failover MAC address. The only way to fix this is to clear ARP on the upstream d...

lucas_kaczmarski · 08-09-2018

Hello, Does anyone know if the above device is able take and refresh ~500 GARP messages at once in one burst from a downstream device? I know that Juniper SRX1500 is having issue with that and many of the GARPs are being dropped and the table doesn...

lucas_kaczmarski · 07-12-2018

Hello, I have a situation where I need to bridge two subinterfaces into one L2 group. So any traffic can flow between TenGig0/2/0/2.602 and TenGig0/2/0/3.602 just as they were switchports. Is that possible at all? Should I use BDI or something ...

lucas_kaczmarski · 08-10-2018

Nice one, thanks.

lucas_kaczmarski · 08-10-2018

The ASA responds to ARP for NATed IPs and that is correct and expected, but it seems that when I change the virtual MAC address of the ASA the GARP updates are not sent for NATed IPs. It's not the intial ARP request that is the problem (that I can...

lucas_kaczmarski · 07-12-2018

Thanks. I have other subinterfaces on TenGig0/2/0/2 and I only want to bridge one of them (.602) and leave other subinterfaces as they are. Does this syntax do it?

Member Since	‎10-14-2017 05:46 AM
Date Last Visited	‎02-14-2024 12:05 AM
Posts	6

User Statistics

User Activity

Cisco ASA gratuitous ARP

Cisco ISR 4331 - GARP buffer

Bridge two subinterfaces on Cisco ASR

Re: Cisco ASA gratuitous ARP

Re: Cisco ASA gratuitous ARP

Re: Bridge two subinterfaces on Cisco ASR