Hi, I have set up GLBP on 2 routers I have in a test lab. One is a serial back to back running at 192k and the second is isdn2e running at 128k. The HSRP side of the operation ( i.e. failover etc )is working well but when I pass traffic over the inte...

Hi,Please review my attached .jpg for a more detailed explanation.I am trying to set up GLBP to load balance 2 routers, 1 serial link (GLBP weight 100) and 1 isdn link( GLBP weight 90) connected to the same router via differnent mediums.I am using os...

Hi,I am having problems upgrading the IOS on my 2600 router. My problem is :Currently I have a 2600 with 16mb on board SIMM memory and 32 Mb DRAM. I am looking to upgrade to the latest 12.3 IOS and have therefore bought and installed 32Mb of SIMM. Ho...

Hi,Please review the attached jpeg for a clearer understanding of my problem.Basically, I am using a Y-Splitter to split the signal from 1 Cisco CABX21MT cable in to 2 cabx21mt's. I am looking to connect these cable to the serial ports of 2 2600 rout...

Hi,I am currently in the process of implementing a network migration to MPLS and am looking to use HSRP. I have searched high and low looking for the appropriate cabling to split a DB15 connector from an NTU into 2 DB60 connectors to plug in to WIC-1...