Jason Tech Guy

Hello Everyone, So after much frustration with QNAP and twisting their arm they agreed to take a loo...

Leo, I did try your suggestion, and unfortunately, that didn't work. I really do appreciate everyone...

Ok, the QNAP was on the latest version, so I have downgraded to an older version, that did not work....

Hello, I tried downgrading to the older versions as you suggested, and it still will not work. If I ...

I will try this and report back 

But it works with a 2960S?

I cannot find anywhere on the QNAP for settings the nic to 1GB. Still looking into this. I have done...

Ok folks, I did the diagnostics tests on the 2960S and I have attached the logs from that and pluggi...

by the way on old 2960S working, what port do they connect?both QNAP ports will connect to any port ...

Here it is, Stored system POST messages:Switch 1---------POST: MA BIST : BeginPOST: MA BIST : End, S...

I did notice that on the NAS they are 2.5GB ports. Also, this might be related... I have a building ...

@Leo L wrote:Hmmmm ... In the 2960X, try configuring the ports to 100 Mbps using the following comma...

I have contacted QNAP and gone over the settings, they are identical to another QNAP with the same f...

Leo, I moved my QNAP over to my 2960S and ran the same test, below are the results Interface Speed L...

Below are the result of a TDR, Port 5 is the DOWN port, and port 6 in the UP port. Interface Speed L...