About a.awan

a.awan · 07-19-2004

I know this question has been asked before and the answer is to have separate content switches per DMZ in order to maintain the security policy. There is an option to have the content switch in front of the firewall and then use only one content swit...

a.awan · 06-27-2004

I have been told that a CSM by default has all VLANs on the Cat 6500 trunked on its connection to the backplane and the catalyst autostate feature does not work in this case as you cannot remove the VLAN from the trunk. To explain it a little better ...

a.awan · 08-26-2003

Has anyone experienced this problem ... While doing a Call Manager 3.3(3) install on a HP DL 380G3 server (meets all Cisco requirements) the installation stalls after asking for OS Disk_3.

a.awan · 11-05-2004

Do you understand the potential pitfalls of disabling STP? Why would you want to disable it? Even if your network is free of physical loops it is always recommended to leave STP on for those days when someone inadvertently (or even intentionally) int...

a.awan · 11-05-2004

Yes it is possible. You can do PAT either on an address you define in a pool or on an interface address.ip nat inside source list pool test overload ORip nat inside source list interface Fastethernet0 overloadWhere is a stand...

a.awan · 11-05-2004

Thats how i thought it would work. Like i said earlier if you have to NAT to the internet also then you will have to use ip nat outside on both interfaces but if NAT is only required for the remote side then ip nat outside on the tunnel interface is ...

a.awan · 11-04-2004

Can you draw a visio of how your setup looks like and post it here? You can also save your router configuration files as text files and upload them here so we can take a look at them and take it from there.

a.awan · 11-04-2004

What is the exact problem you are facing? Is it the VLAN assignment itself or is it getting the IP Address afterwards via DHCP? I have gotten it to work in a test environment but unfortunately with Foundry switches; have not gotten a chance to test i...

Member Since	‎06-21-2001 11:13 AM
Date Last Visited	‎08-18-2017 03:50 AM
Posts	486
Total Helpful Votes Received	293

User Statistics

User Activity

Load balancing across DMZs - Revisited

CSM Trunk

Call Manager 3.3(3) Install on DL 380 G3

Re: Disabling STP

Re: NAT/PAT Configuration

Re: IPsec/GRE with NAT

Re: Cisco 2650 Help1

Re: wired dot1x, anyone got it to work