I have about 8 SPA303 phones off of a UC320W. I have two phones that the PC port appears to "stop" working occasionally.. Meaning that the users have laptops and disconnect at night and when they come in the morning, the plug back in and usually are ...
I created a hunt group in our UC320 with 4 members. It is configured as a sequential hunt always trying the first person in the sequence and try each extension for 6 seconds then roll to the next in the sequence. However, if the first is already on t...
Although my question is related to the original "Netowrk topology/setup" discussion, my case was not specifically asked. Employees from my site VPN into our site to access services and data remotely. For that we are using a Cisco RV042., sufficient f...
I just installed a UC320W with a bunch of SPA303 phones. I was quite surprised on how easly it was to configure and get running. I have one question (at least for now); how do I program the phones like add a user definable ringtone? If I try to go in...
We have an RV042 router at location that we are a tenant of. They ran a security scan of it and found that TCP timestamp is on. Is there a way to disable that feature? I do not see an option in the web management tool. Any ideas?Thanks,Keith
It has not happened in the past few days. I will wait to see it happen again and verify that indeed the phones are in the incorrect address range. Thanks for the suggestion.
Thank you again. I did try that as well. My management wants to have the hunting functionality so that it will always start with one employee and roll over if they aer busy with a call already. I really appreciate all of he hints. I still think this...
Thank you for the tip. I configured the phone itself to disable the call waiting feature and it now will roll over if the line is busy. The only thing that is a bit odd is that in the scenerio of twos defined with one being ni a hunt group and the e...
Julio, Actually if the user does go into DND, that actually works. However, they would not normally do that everytime they answer a call. The system should probably have an option to rollover when an extension in the hunt group is "busy/off-hook" ...
I am using FXO lines. My telco provider does have those in a hunt group that is working fine. My question is the hunt group I created using phone extensions on the UC320.
