Hey all,Need some help on the best way to configure rate limiting and/or traffic shaping for a single interface.Have a C3750-12S with an interface connected to a 10Mb circuit (leased line) 10Mb is shared over a 2 business units who respectively want...
Hi all,I know probably a very simple one however getting a little confused.I have a single switch stack comprising of 2 x c3750 connected via stackwise.Customer is connecting to it with 1 fiber connection currently and I have another ready to be plug...
Hi People,Can anyone help..I have a established VPN between NS500 and AS5505The following diagram shows whats going on.customer source subnet: 192.168.2.0/24Source NAT to 10.160.64.33NS500: sub int 1.3 : 10.160.64.1Destination NAT to : 199.53.28.17...
hey guys,Please help! I bought 3 refurbed c3750-12S to add to an existing switch in a stack. had version mismatch message so was able to tftp bin file from the master to 2 of the switches no problem.The 3rd didnt took the image and now is in a boot l...
Hey guys,I have 4 x cisco 3750g-12s in the following config attached diagram.Im running rpvst on all the switches and something seems to be incorrect with the config.As topology is in a loop providing redundancy from what i understand one port should...
I think the image is incorrect ? Im running c3750-ipbase-mz.122-35.SE5.bin on the other 2 (1 is actually ipservices and not base)if i use the following image do you think it will work?c3750-i5-mz.122-25.SE.bin
Thanks Edison.The RV082 doesnt support subinterfaces. Im going to have to go to a bigger piece of kit like the following I think :cisco 1805 integrated services router from looking at the product advisor..1: Is the diagram attached in my post the cor...
Hello Guys,Not sure why no responses to this one. Maybe in the wrong place?To reiterate..I have a datacenter ISP connection coming into my network shortly. (No internet connectivity at the moment)50Mb coming via a colocated ISPThe ISP have given me a...
What I mean is can I use the same standby addresses for each sub interface?eg:interface GigabitEthernet0/1 ip address 172.31.102.6 255.255.255.0 media-type sfp standby 1 ip 172.31.102.5 standby 1 timers 1 2 standby 1 priority 110 standby 1 preempt st...
Hi Richard,I dont want to route between the VLANS per se . Just for each to be able to reach the router..eg each VLAN is for a customer.vlan 1 = 10.115.11.0/28vlan 2 = 10.115.11.16/28etcCustomers need to connect to the router and access a server behi...
