About benhanson

benhanson · 03-17-2009

Does anyone know if the 'service config' command is required for switch clustering to work properly on 3500XL series switches? I'm trying to eliminate the TFTP broadcast from some of my switches. The config was setup by someone else several years a...

benhanson · 03-08-2009

I'm trying to get Apple's l2tp/ipsec client to function with an ASA. I've successfully connected with Cisco's client, with the desired access to the remote subnet, but as soon as I add this command:crypto ipsec transform-set TUNNEL_ESP_3DES_SHA mode...

benhanson · 10-13-2008

Has anyone had any issues adding device compatibility for the 7906 to CM 4.1(3)? I've installed DevicePack 4.1-78, the proper load info is displayed in the Device Defaults page, but when I go to add a new phone, 7906 is not available in the drop dow...

benhanson · 05-08-2008

I'm configuring a 2811 with a PPWR-DCARD-16ESW card, I can't figure out how to get traffic from the switch ports to one of built in ports(Fa0/0 or Fa0/1). I'm assuming I don't need to run a 6" patch cable from one end of the router to the other.

benhanson · 05-08-2008

Does anyone know of a document that outlines the different authentication options in IOS. Specifically I'm trying to understand the interplay between using radius, local, none(what is this option for?) and how the presence of an enable secret affect...

benhanson · 09-23-2019

In case anyone else stumbles on this zombie thread, 3 things that helped with my 1921, getting me from 30mbit to 100mbit . . . ip cef, removing all extraneous ACLs, converting extended ACLs to standard ACLs if the extended functionality wasn't neede...

benhanson · 02-11-2019

For all those struggling with 50% packet loss, no routing, no ICMP through an LTE cellular interface, on a 2901, 1901, 1921, etc, etc, disable IP CEF on the cellular interface. It is both a global and interface specific command. It may not be a bug...

benhanson · 09-06-2009

It's really no that simple. If the DSL modem has a built in router, then it will have the public IP address and it will establish a LAN subnet, then the WAN interface of the 5505 will have a different IP address on the LAN subnet defined by the DSL ...

benhanson · 03-08-2009

I added the 2nd config, Cisco client still works, apple client doesn't. Just to retest, I added mode transport to CISCO_CLIENT without changing anything else, and sure enough, apple client can connect but no traffic passes.I then tried simply changi...

benhanson · 03-07-2009

Yes.

Member Since	‎10-10-2002 12:30 PM
Date Last Visited	‎04-01-2022 12:03 AM
Posts	101
Total Helpful Votes Received	23

User Statistics

User Activity

Switch Clustering & Service Config

OS X 10.5.x L2TP/IPSEC VPN Client + ASA 5505

7906 with CM 4.1(3)sr6a

PPWR-DCARD-16ESW in a 2811

Authentication commands

Re: Van you post your config? I

Re: We're using 15.4 and the

Re: 5505 with RV042 - outside ip address?

Re: OS X 10.5.x L2TP/IPSEC VPN Client + ASA 5505

Re: ssh and mac