About svemulap@cisco.com

svemulap@cisco.com · 03-03-2019

Check Control Connection StatusGeneral checksCheck that a Valid Certificate Is Installed on the vEdge RouterCheck the vEdge Router ConfigurationCheck the Clock TimeCheck for Routing IssuesCheck the Route Table for a Valid Route to the Next HopCheck f...

svemulap@cisco.com · 02-08-2024

Think of System-IP as a router-ID. It has to be unique in the network.Each device will have a unique router-ID.In the context of SD-WAN, a given device uses this system-IP to reach another node.You can see the system-IP, via show running-config or s...

svemulap@cisco.com · 02-02-2024

Good to hear that everything worked out !! Good Luck on further testing !!

svemulap@cisco.com · 02-01-2024

Yes. Make sure you have the NAT enabled, on the transport (tunnel) interfaces.Also, not sure, what kind of modem if any you have northbound.We have found some issues with dinky modems not maintaining the unique flows from NAT perspective,if the Edg...

svemulap@cisco.com · 02-01-2024

Make sure you have underlay reachability.You can check, for example: by pinging the transport IP

svemulap@cisco.com · 02-01-2024

If the two devices are in the same site-id, BFD won't come by default.The assumption is that they are in the same time and they can reach each other through LAN/Service side.If you still would like to have a BFD session, need to allow-same-site-tunne...

Member Since	‎10-18-2017 12:12 PM
Date Last Visited	‎03-20-2024 12:30 AM
Posts	276
Total Helpful Votes Received	449

User Statistics

User Activity

SD-WAN Routers: Troubleshoot Control Connections

Re: vManage-system-ip Vs System-ip

Re: Can two SD-WAN routers with same Global IP establish Tunnel Sesson

Re: Can two SD-WAN routers with same Global IP establish Tunnel Sesson

Re: Can two SD-WAN routers with same Global IP establish Tunnel Sesson

Re: Can two SD-WAN routers with same Global IP establish Tunnel Sesson