Hey all,
per request, I need to change my service to allow for multiple interfaces to be specified. Currently, I have a container named "interface" where I configure one interface. I am looking to restructure this container to be a list where the...
I am wanting to spawn off syslog messages after creating a service. The syslog should have details about the service. Is there a way built into NSO to create a custom NSO syslog message with these details. If there is, could someone point me in th...
Could anyone tell me the best way to limit the possible completions when creating a service to just when leafs are available in my YANG model?
I only want to expose bgp_info, interface, and vrf_info when in the configuration mode.
Thanks for the response Ram!
I just had an idea. I could keep the interface container and make three list: iOS, iosxr, Huawei and then add the uses subinterface_grouping inside each of those list. Finally, I would need to figure out the best way...
Hey thanks for the response. I want to exclude the completions that are not explicitly created by my yang model. I would prefer to not show completions such as re-deploy when configuring the service. I would even be fine with separating the options...
