I am preparing a bill of materials for an AP install. The AP model is the cisco AIR-CAP2802E-B-K9. The antennas is AIR-ANT2524DW-R which is a dual band dipole. I noticed the 2802E has 4 antenna ports. Do we install an antenna on all 4 ports? So ...
We have a new installed DSL circuit. The ISP provided us with static IP info.
Gateway IP
Usable IP address
Subnet Mask
I have setup a router interface from the modem to provide internet. The interface IP address is configured as the usable IP and...
Hello - I'm wondering if I'll be able to access a pre-configured switch after deployment without TACACS credentials. The line that reads login authentication *ACS username" (I've hidden the actual username) will this require TACACS? Or will the acc...
I need to create a virtual interface on a router for an ISP modem to provide internet access. The ISP has provided the IP, mask, and gateway for the modem. However, what will the IP address need to be for the interface on the router? Do I just cho...
Hello - I have a job interview for a Wireless Engineer in two days. The job will consist mostly of performing wireless site surveys for corporations. I have been supporting an enterprise CAPWAP network for years now, but I'm afraid I need some brus...
I'm sorry I'm not able to post the config for privacy reasons.. Do you agree that if the modem was truly set as static, it wouldn't provide an IP address when I set the router interface to DHCP?
Hi George - I found the line "aaa authentication login *ACS username* group tacacs+ local"
So you're saying the tacacs+ local portion will allow local login if tacacs isn't available?
Hi Paul - I'm not sure if the modem will be static or DHCP. They wanted us to set the interface beforehand, but we can plug a laptop into the model and see what we get. The .100 interface is part of a standard config they sent us. They have all of...
