Level 1
Level 1
Member since ‎07-15-2002

User Statistics

  • 205 Posts
  • 4 Solutions
  • 0 Helpful votes Given
  • 13 Helpful votes Received
Recent Badges
1 Accepted Solution
10 Helpful Vote
1 Helpful Vote
50 Replies
20 Replies
10 Replies
5 Replies

User Activity

In XR 12000 (12410) and CRS-1, what are the acceptable temperatures for the two devices (both the inlet and the exhaust)? When should we conside the temp is high?
We have two servers connected to the same 4500 Multilayer switch, the two servers are working in active/stanby mode using virtual IP address between the two servers. On the 4500 switch, the MAC address of the servers virtual IP is the MAC address of ...
We have a very high CPU utilization on one of the RPM (route blade in MXG, the process EIGRP PDM is the cause of the high CPU.. How can we solve that? RPM#sh proc cpu sortCPU utilization for five seconds: 99%/63%; one minute: 99%; five minutes: 99% P...
When I try to convert route map in IOS to RPL in IOS-XR, Cisco documenatation has this example..ip prefix-list 101 10 permit le 32 20 permit le 32 30 permit 40 permit 50 permit 6...
I have a 2800 router with two serial interfaces, for some reason the second serial showing the clock rate command. we tried to remove it with the "no" but it does not work.. Whenever we connect the serial cable to this interface, it shows as DCE not ...
Community Statistics
Member Since ‎07-15-2002 12:18 AM
Date Last Visited ‎08-18-2017 03:51 AM
Posts 205
Total Helpful Votes Received 13
Helpful Votes From