When i tried to upgrade the existing code to c6msfc2-jsv-mz.122-14.ZA2.bin it went to boot mode. I had to backout to the old one again since it dint do any routing funcitons. Is there any bug in the code or is not compatible with Catalyst 6509 runnin...

When i tried to discover a circuit on a router 'A' using Nethealth server(on firewall), it doesnt respond to SNMP requests. But another circuit on router 'B', which is in same Vlan as router A, was discovered by Nethealth. The snmp configs are simila...

How to calculate total bandwidth utilization of a circuit if i have In and Out data rate? Is there any formula?

A serial interface of 3640 router was configured with a specified value. While i try to remove the clock rate command completely ( no clock rate) i get an error message as "FECPM PM doesn't support clock rate 0". Now how to go about this?