I have had CW2K running on a Solaris box for over 2 years. Outside of some minor log file issues, it has been running fine. Just recently the app has started showing some odd web page output. The opening page now only displays a small black squar...
Error log entries. I am really looking for an avenue to research these log messages without going through this forum. Is there a place these messages are posted with possible cause/effect/solution?Thu Oct 09 11:16:08 MDT 2003: Running servlet{ jav...
My daemons.log is over the size limit even after backup and reboot. I am getting some of these errors:ERROR: CORBAREGISTRY:Unable to connect to ManagerControl object. Reason: org.omg.CORBA.BAD_PARAM: minor code: 0 completed: NoIt is also full of...
Confirmed. Once 1.4.2 and 1.4.1 JRE were uninstalled, CW2K worked fine. When will CW2K be updated to allow support of newer/current JRE or JPI versions. This problem will appear again if these newer versions are installed on the clients before CW2K...
It does appear to be all of our users and JPI 1.4.2 shows up in all PCs in the Control Panel. Not sure how to switch to make sure that 1.3.1 is being used. But, both 1.3.1 and 1.4.2 are in control panel, and the 1.3.1 Icon shows up in the task bar w...
What about devices that do not support SSH yet?If I set the order to SSH, TFTP, Telnet, RCP how will this affect devices that are not SSH capable.I am assuming that if they do not support SSH then they will try the next options, in order and should s...
I did see this document and the chart listed. However another document says:Limitations and RestrictionsThis section describes the limitations and restrictions for the Catalyst 6000 family NAM software release 2.1(2):You must run Catalyst software re...