I am wondering if a network interface on a Cisco 2600 can have two IP addresses on the same network. For example, can two subinterfaces on a physical network interface have these IP addresses 192.168.1.1/24 and 192.168.1.2/24? Can it be accomplished ...

Hi! I have been asking this couple of times now but no solutions for my problem has come up yet.Is it possible to acquire all the available IP numbers from ISP to the Cisco 2600 router with ADSL WIC ? My ISP is providing 5 dynamic public IP addresses...

Hi! I asked this before but no helpful advice came up.I'm running C2600 with WIC-1ADSL module. It is connected to normal ISP providing end users (home users) five dynamic public IPs for five different hosts.Inside network is running on private 192.16...

I'd like to configure multiple BVIs (Bridged Virtual Interfaces) to Cisco router. How can it be done? I cannot create BVI 2 unless I have another bridge-group. To clarify the idea, I included my current config. It is running on ADSL with WIC-1ADSL. I...

Hi!Been browsing through the forum and also Cisco TAC for a sample configuration. I need to accomplish an Internet connection via ISP with ADSL. The information from ISP are as follows:RFC 1483 Bridge, VPI=0, VCI=33ADSL Modem ANSI T1.413Encapsulation...