FMC is sending eStreamer logs to Qradar, when we look at the logs, source is being seen as FMC, how to identify the original FTD device that is sending the logs? Looking at the eStreamer payload, I see the field flowStatistics.deviceId=3 but I am no...
I ran into these errors while using Firewall top talkers feature, does anybody know what does this mean?
Cisco ASA Firewall Top Talkers: Error: read ECONNRESET
Looking through Cisco docs, it only mentions routers, switches, and AP. To roll out a large number of FTDs, wondering if there is any zero touch provisioning like what is being offered on Cisco NFV solutions with ESA/APIC-EM/PI.
When I checked the interface status of ETH1/1 on FXOS CLI, it says port is not connected and it is supposed to be the management interface of ASA. Whom to contact to correct this?
Recently had to do this. In brief, you can use ISE-PIC (can be separate node or can be enable in existing node as a persona), which basically is identity source, on the backend it can integrate with ADs using WMI (few other methods are out there as w...
When the primary Firepower Management Center fails, you must promote the secondary Firepower Management Center to become the active unit. So its not automatic, manual steps by User. Under System/Integration/High Availability, "switch peer roles" butt...
Yes, Overview/Reporting/Report Templates, you can create new report (e.g add bar diagrams) where table field can be connection events with the X-axis as ACP.
ACP rule search is very limited as far I know, on the right corner, we can filter by device, and there is search field on the right corner, where you can search to match the input field (IP address, rule name , protocol, ports etc) . One cannot searc...
