About christopher_tan

christopher_tan · 11-05-2015

Hello all, I would like to get some solution on below. 1. I have a single router which connect to two different provider internet circuit (circuit A and circuit B) 2. WAN facing running BGP 3. LAN facing running eigrp 4. LAN have two public subnet ...

christopher_tan · 05-28-2015

Hello ALL,I would like some help to advice me if there any faster way to enable/configure 400 users for the Extension Mobility (EM) ?The requirement is to allow users to log-in to host phone from any seat within office area. I know there are numbers ...

christopher_tan · 02-12-2015

Hello All, I need some help on below.- ISP-1 provided two routers (R1 and R2), each router connect to a different internet circuit (ISP-1 and ISP-2 circuits)- Locally have a customer router (R3)- Locally have a public DMZ (203.xxx.xxx.xxx/24) Require...

christopher_tan · 01-28-2015

Hello all,I have a C3750X-24S and i configured FastEthernet0 with ip address (10.251.157.2) and 10.251.157.1 is connected to a firewall (firewall allowed any-any now). Firewall has default route to 10.251.157.2 configured.Switch is connected to WAN r...

christopher_tan · 11-19-2015

yea, both isp1 and isp2 was there. I type in wrongly in last post. router bgp 64520 bgp log-neighbor-changes neighbor 10.1.1.2 remote-as 9498 neighbor 20.1.1.2 remote-as 9498 ! address-family ipv4 redistribute connected redistribute static neighbo...

christopher_tan · 11-18-2015

Hi Paul, I removed the "allow-as". Do i require to have that "PREPEND" ? If yes, is "permit 10" correct? Here the current configuration: access-list 80 permit 200.2.2.0 0.0.0.255route-map isp1 permit 50match ip address 80set as-path prepend 64520 6...

christopher_tan · 11-16-2015

it is now "ip load-sharing per-packet" on both g0/1 and g0/2 interfaces. Below the output. #sh ip cef exact-route 100.1.1.0 8.8.8.8100.1.1.0 -> 8.8.8.8 => IP adj out of GigabitEthernet0/2, addr 20.1.1.2#sh ip cef exact-route 100.1.1.0 8.8.8.8100.1.1....

christopher_tan · 11-16-2015

interface g0/1 only outgoing traffics, while interface g0/2 both incoming/outgoing traffics.

christopher_tan · 11-16-2015

Network Next Hop Metric LocPrf Weight Path *m 0.0.0.0 10.1.1.2 0 9498 i *> 20.1.1.2 0 9498 i *> 20.1.1.0/24 0.0.0.0 ...

Member Since	‎01-28-2015 12:53 AM
Date Last Visited	‎08-18-2017 03:51 AM
Posts	20

User Statistics

User Activity

WAN Load Balancing

FAST way to Configuring Extension Mobility for 400 users

WAN load balancing question

WS-C3750X-24S - FastEthernet0 question

yea, both isp1 and isp2 was

Hi Paul,

it is now "ip load-sharing

interface g0/1 only outgoing

Network Next Hop