Team
I have some issues with a PAT on a cisco ISR4331, the PAT is changing the port # to a lower port from inside local to inside global, and that is causing that the traffic is not passing correctly, I just can ping from sourece to destination but n...
Team,
I have a Cisco ISR 4331 router and I need connect to a 100base LX/LH SFP transceiver module Single Mode, I saw there is 2 SFP 100base for this router
GLC-FE-100BX-D GLC-FE-100BX-U
Do you know which interface type BX10-U or BX10-D, is compatib...
Finally I got the answer, it is a bug on the IOS-XE I was able to confirm from engineering that there was a change in behavior (code wise) where starting in 15.5(3)S5 and above, it should preserve the port. According to them, this was tracked under “...
Good point, I Will try to use the interface instead the ip, I Will request to the customer a test window and I Will return here with the results. thank you!
Thank you!
But it is strange because I have the same PAT configuration in 5 routers C3825 (c3825-advipservicesk9-mz.124-15.T10.bin) and are not changing the port #, they keep the same just this ISR4331 is changing the port wit hte same config.
C3825 ...
Chrihussey
That is a great information I will try to get a GLC-FE-100LX I am sure that I have one in somewhere, let me get it and I will replay with the results.
Again, thank you so much.
