Hello,            I have SG300-24 in L2-Mode uplinked to Sonic FW. The only settings that seemed to work  is100Mb Full-duplex on both sides. If there is any other setting like auto-auto or 1000Mbits on both sides link goes down.I also set portfast en...

We have a single SG300-28 in L2 mode with 1.1.1.83 vlans 3 virtual interfaces and 1 parent interface configured on the sonic firewallSwitch(trunk allow all)-->sonic( 1 parent interface and 3 virtual IP's)vlan 10  192.168.10.1vlan 20  192.168.20.1vlan...

Hi,      These are our first switches and seems like GUI is lot different than the online. Out intervlan routing is o not working. I am absolutely sure that I setup the switch in L3 mode since it allows me to create mutiple interfaces. I am hoping th...

I am relatively new the configuring network switches. Could someone point me in right direction to configure SG300-28 as a DHCP server?From the people I talked based on device specs it should be able to act as dhcp server. However, if we cannot, can ...

I setup switch in layer 3 mode.I have a access port in vlan 10 and a access port in vlan 20.I am able to ping form vlan 10 client to vlan20 default gateway (192.168.20.1)I am able to ping form vlan 20 client to vlan10 default gateway (192.168.10.1)Ho...