About msompong1

msompong1 · 04-07-2021

Thank you Marcelo for the good information.

msompong1 · 04-07-2021

Thank you Damien,So during the upgrade not require the de-register the node right?Can I say it like ...

msompong1 · 04-06-2021

Hi All, I've the plan to upgrade ISE from 2.3 to 2.7 from my 2 nodes VM (active/standby).Could you p...

msompong1 · 04-01-2021

Hi Rasika, The capture done by using laptop with Wireshark connect to the same AP with the intereste...

msompong1 · 03-31-2021

Hi All,I am using the WLC with FlexConnect mode , I have the external DHCP server for assign the IP ...

msompong1 · 01-20-2021

Hi Marce1000, It working fine now after upgrade to the latest IOS version.Thank you.

msompong1 · 01-20-2021

Hi Marce 1000,Please see below.

msompong1 · 01-20-2021

Hi All,I have the brand new Cisco 1000 switch with the IOS 15.2(7)E1, Normally my company use the MA...

msompong1 · 01-11-2021

Hi Mohammed, Thank you.

msompong1 · 01-11-2021

Hi Rob, Thank you for your explanations.

msompong1 · 01-10-2021

Hi All,I'm running 2 VM of ISE 2.3 patch 6 with deployment mode as below But once I've tried to enab...

msompong1 · 09-07-2020

Hi All,I've notice that once the client move from current AP to other AP will have the DHCP request ...

msompong1 · 08-10-2020

Hi All, I've the project to create the internet link for the critical application , The requirement ...

msompong1 · 08-06-2020

Hi All,I would like to send the log in WLC GUI below to the syslog server , Please advise how to get...

msompong1 · 08-04-2020

It's working after config the AP IP address, Thank you so much.

Date Registered	‎10-27-2017 06:44 PM
Date Last Visited	‎04-07-2021 09:46 PM
Total Messages Posted	39
Total Helpful Votes Received	30

Re: Upgrade the ISE on 2 nodes (active/stand by)